User manual for Neo Wood
Neo Wood gives Beolab 7 speakers have a beautiful wooden front panel – made of high quality oak that exudes a sense of timelessness.
Neo Wood creates this for you.
Experience the epitome of excellent sound with a B&O loudspeaker, a true masterpiece of sound engineering and design.
The smoked oak finish adds an elegant touch and elevates the speaker's aesthetic appeal to new heights. The combination of oak and smoked oak creates a nice contrast that enhances the modern look of this sonic wonder.
With its sleek and stylish design, the B&O speaker is not only a feast for the ears but also a visual treat, making it the perfect addition to any modern living space.
How to apply Neo Wood on your Beolab 7 speaker
It is easy to put on Neo Wood wooden slats on a Beolab 7 speaker from B&O.
Carefully remove the current front of the speaker.
Push the front from right to left (seen from the front) and you can easily remove it
Mount carefully Neo Wood front unit on Beolab 7 from left to right.
You must ensure that the plastic feet on the front unit fit with the counterpart on the Beolab 7 before you press it into place
Note here:
The wooden slats are held in place by a plastic clip and can come loose if you do not press against all the wooden slats at once.
Use a wooden block or something plastic - eg a small cutting board, or a list or similar, so that you press on all the slats at once.
The upper lamella is fixed with a magnetic solution and can come loose. If necessary, remove it carefully before mounting. Attach it again afterwards when you have attached the entire wooden slat
Check that the wooden front faces correctly before installation.
The bottom has a visible part of the plastic holder – that part must face down on the Beolab 7 speaker. Picture on the left shows the top of the wooden slat. Check that it faces upwards before mounting
